Silkroad Online Forums

Haihai, this is like the second thingy i do, where i actually try to do a good job on O.o

It was relatively hard, and it took a while, i think it's not that bad




I think it's ok after all, i tryed to make it l00k pro with the sticky and shit lols, i think it looks alright, what do ya'll say about it?

Comments plýss

Parts look blured.

thats because of the bg i took it from
could do nothing about that >.<
i just liked the thingies so i was like, cuttttttttteeeeeeeee imma make a render lol

enlighten me plz

i dont see wat u did there... cant u just cut it out and it looks exactly the same....

crazyskwrls wrote:enlighten me plz

i dont see wat u did there... cant u just cut it out and it looks exactly the same....

That's what he did, cut it out.

It's called rendering.

Oh, nice one man.

If you want to get rid of the blurred sides, you should use the pen tool for rendering (assuming you didnt?).

BrokenSaint wrote:Oh, nice one man.

If you want to get rid of the blurred sides, you should use the pen tool for rendering (assuming you didnt?).

i diiid lol
i use anti aliasing O.o
but still, trust meh, if you see how the BG is, its the bg that makes the characters look kinda blurred in some places i think/hope if not plýs tell me how i get it to not be like that lol, i think it might be the anti aliasing thingy, idk, just guessing

Hm, probably looks that way cause you included part of the BG. That's nothin' tho good job.

BrokenSaint wrote:Hm, probably looks that way cause you included part of the BG. That's nothin' tho good job.

Thanks mate

Save as .png
Looks good though.

It looks like you set the feathering too high or to the inside when you were anti-aliasing.

note: I dont know what they call it is PS, cause I dont use it. In PSP, they call it feathering, how far inside or outside the outline you want it to anti-alias. I generally use an outer feather then use the erase tool with a 75% hardness to crisp the edges by nipping off the small bit left over. (Dunno if that makes sense to anyone)

Yeah, it called "feathering" on Ps as well nightbloom.

Producing a useable render pretty much comes down to the stocks you choose to render. As with anything you do quality will always play a big roll in how good it looks, in this case the Bg is bleeding into the focal. You usually have to go back with a bit of clone stamping and re-drawing lines with a thin brush to repair it. all in all not bad just try to find higher quality stocks.

Aye, i see
thanks for the comments
^^

as it was already posted, the only problem is the feathering